t option is used for continuous ping messages: ping –t 192.168.1.10įollowing the figure shows the ping usage for the Zynq eth0 set to static IP address 192.168.1.11 and host PC IP address set to 192.168.1.10

The round-trip delay in communicating with the host.

Whether a remote host is active or inactive.

It uses a series of Internet Control Message Protocol (ICMP) Echo messages to determine: Using the PING:The ping command is a very common method for troubleshooting the accessibility of devices. 192.168.1.10 for the LAN using the Local Area Connection properties

Power cycle the Zynq kit, once the Zynq boots the Linux enter the following commandsĢ7. Connect the power supplies UART cable/PC to Zynq board, and connect the Ethernet ports of PC and Zynq7000 AP SoC with RJ45 cableĢ6.

NetPerf executables: NetPerf and NetServerĢ5.To run the demo with pre-build images of the tis techtip or Images build in the above steps: Place all the required files in to SD card: To run the demo with provided pre-build images skip to step 22 or Follow the procedure explained in the web pages for getting the sources, building the U-Boot and Linux sources:Ģ4. Iperf benchmarking utility for baremetal solutionĢ3.NetPerf benchmarking utility for Linux based solution.Using the Wireshark network protocol analyzer.Basic troubleshooting techniques for the link establishment.Creating the design for Zynq-7000 AP SoC with Ethernet using the Vivado and SDK.This tech tip explains the following sections: XAPP1082 -Zynq-7000 Linux Ethernet Reference Design.XAPP1026 - Zynq-7000 AP SoC Baremetal Reference Design.To follow these steps users can use the pre-built images available at following Xilinx resources: This techtip describes the step to use the PING utility, Wireshark network protocol analyzer, iperf and Netperf benchmarking tools. The Programming Logic (PL) sub system of the Zynq-7000 AP SoC can also be instantiated with the additional soft AXI EMAC controllers if the end application requires more than two Giga bit Ethernet Controller. Zynq-7000 AP SoC has an in-built dual Giga bit Ethernet controllers which can support 10/100/1000 Mb/s EMAC configurations compatible with the IEEE 802.3-2008 standard. This Tech tip explains the Ethernet debugging and benchmarking methods using the Zynq-7000 AP SoC

Netperf for windows